BATMAN BEGINS – 3rd Third Brake Light Vinyl Decal Mask Kit

BATMAN BEGINS – 3rd Third Brake Light Vinyl Decal Mask Kit – Customer Review:

LOOKS VERY COOL ON MY BLACK JEEP!

I’m not sure what’s wrong with these people, but I had no trouble at all applying this decal to my third brake light. I even had to do it twice because I picked the wrong size the first time, and had no trouble either time. Then again, I have some semblance of patience and coordination.

If you want this task to be easy, take the plastic of the third brake light off your car first. It seems insane to try this while the plastic is still attached to the vehicle. On my Grand Cherokee, the plastic third brake light has only two screws and comes off in seconds.

Cut the decal to generally fit the size of your brake light, but try to be generous with overlap. I peeled the whole decal off the backer, placed the brake light in my lap, then eyeballed placing the decal on the plastic centered and square. *NOTE*: Work from the middle outwards. While holding the two ends of the decal with your hands, bend the middle of the decal down towards the middle of your brake light, and lightly touch the decal to the plastic where you want it to be. Then work one side at a time. Just kinda lay the side you aren’t working on down lightly, then work the other side slowly from the middle, using your fingers to prevent bubbles. If any bubbles occur, gently pull the vinyl back up in that spot and reapply. Then go to the other side, pull it back up if it stuck at all, then do the same. Stretch the vinyl around the edges and corners so it has a clean look. Use a very sharp Xacto knife to trim excess from the edges, but leave some overlap so you can wrap it around the edge for a better hold.